Can Lutron control fans?

When paired with the system you can: Control your fan speed using Alexa or Google Home. Control the fan when you are away from home using the Caséta App. Create scenes with your Fan and Light controls to set the mood quickly right from your phone!

What ceiling fans are compatible with Lutron?

Basically any pull chain ceiling fan (Permanent split capacitor) will work well. Having a light kit installed would require a dimmer to handle the lights. LEDs and shared neutrals might be problematic as the motor load form the fan will most likely cause “unsatisfactory” performance with the LEDs.

Can a dimmer switch control just the light on a ceiling fan?

Standard dimmer switches should never be used to control the fan motor on a ceiling fan because the dimmer could damage the fan motor, or overheat and start a fire.

How do I reset my Lutron light and fan switch?

Press and hold both the “Light Raise” and “Fan Lower” rockers simultaneously. 3. While holding both rockers, push the “FASS” in. Note: Resetting one set of controls (1 wall station + 1 canopy module) will NOT reset all sets of wall controls.

Do Lutron switches work with Hunter fans?

Now, using the Lutron App, homeowners can easily adjust their Hunter Symphony and Signal ceiling fans (including the light) to a preferred setting, and easily set the perfect scene with other lights and shades.

Can I control my ceiling fan with Alexa?

ALEXA AND GOOGLE-CERTIFIED – This device is certified by Amazon and Google to work with Alexa and the Google Home Assistant. Control your ceiling fan with voice commands. You’ll never need to reach for the light switch or the remote again. Controlling a ceiling fan and fireplace has never been easier!

What is the difference between light dimmer and fan speed control?

Talking about the differences between a dimmer switch and a fan speed regulator, the basic one is that the dimmer reduces the voltage. In contrast, the fan control reduces the amperage. The fan speed controller regulates the rotor’s speed by increasing or decreasing the current, or amperage, available to the rotor.

How do I reset my Lutron light?

How do I factory reset my Lutron Caseta switch? Rapidly tap the top “on” button three times and on the third tap hold until the lights connected to the switch begin to dim up and down, immediately tap the top “on” button three times rapidly. The connected lights will then alternate dim and bright slowly.