What is control panel in fire alarm system?

A fire control panel is a component that offers control through a fire alarm or notification system. Throughout the building, sensors are installed. These sensors redirect information to this control panel. They include environmental changes that could detect the presence of a fire.

How do you acknowledge a fire panel?

In order to acknowledge and silence the trouble from the fire alarm monitoring panel, simply enter * 2 and then hit the pound key. This will silence the keypad, however the yellow light will remain lit until the trouble is resolved.

What is a fire alarm panel called?

An FACP is the “brain” of the fire alarm system to which all other devices are connected. When an initiating device (such as a smoke detector or a manual pull station) transmits an alarm signal to the FACP, it activates the notification devices to alert the occupants via audible and visual alarm devices.

What information will the fire alarm panel be used to display?

Indication of fire signals, fault signals and their location. Manual control to facilitate actions such as testing, disablement of devices, triggering of fire signals, silencing of audible fire warnings and resetting the system after a fire signal.

What is the difference between an annunciator panel and a fire alarm control panel?

A fire alarm annunciator is commonly called a remote annunciator and is located in an area of the building separate from the FACP. The remote annunciator notifies the facility staff and other people in the building that the fire alarm has detected a fire, smoky condition or system problem.

What are the 7 types of alarm system?

What Are the Different Types of Home Alarm Systems?

  • Electric Current Alarm System.
  • Wired Alarm System.
  • Wireless Home Alarm System.
  • Unmonitored Home Alarm System.
  • Monitored Home Alarm System.

What are the two types of fire alarm systems?

There are two types of fire alarm initiating devices: manual and automatic.

  • Manual initiating devices are manual pull-down stations that can only be activated by hand.
  • Automatic initiating devices trigger automatically in the presence of fire.

How do I reset my fire alarm control panel?

Reset Your Smoke Alarm

  1. Turn off your home’s main circuit breaker.
  2. Unmount the alarm and disconnect the power cable connected to it.
  3. Remove the battery, press the test button for 15 seconds.
  4. Reinsert the battery, reconnect the power cable and put the smoke detector back on its mounting bracket.

What alarm signal must be sounded by the alarm bells in case of fire?

The fire signal must be a continuous blast of the whistle or electrical bell for not less than 10 seconds. However, in most of the vessels, the fire signal is rung continuously on the alarm bell.

What does NAC stand for in fire alarm?

A: Each NAC (Notification Appliance Circuit) in a fire alarm panel or booster power supply has a maximum current rating. This information can be found in the manuals provided with the panels. The total current draw for all the devices connected to the circuit cannot exceed the NAC rating.

When activated what does the fire alarm panel show you?

The fire control panel receives information and status reports from each device and indicates its exact location if there is a fire, fault, smoke, heat, or contamination.