What is a good trolling speed for walleye?
The best trolling speed for fall walleye is from 1.3 to 1.8 mph (and you can go up to 2.2 mph early in fall). Water temperatures start to cool down in the fall, and it’s best to troll slower than in summer, which means you’ll hardly ever go above 2.2 mph.
What is the ideal trolling speed?
In general, trolling speeds between 1.5 and 2.5 mph, as measured by GPS, are a good starting place for most species like walleye, trout and salmon.
How deep do you troll for walleye?
This lure naturally dives form about 4 to 6 feet and with a weighted setup you can troll a Rapala efficiently in depths of 10 to 20 feet. When fishing deeper water of 20 to 30 feet, I like to use a crankbait with a longer and deeper lip that dives deeper.
When should I start trolling for walleye?
From brown trout fishing and walleye fishing in early April and May, all the way to November when you’re musky trolling. There’s no bad time to troll, but right now in mid-July is a great time for walleye trolling in open water.
How do I make my lures deeper when trolling?
If you need to go deeper, just let out some backing until your target depth is reached. On the lure end of the line, remove a short section of lead as before and tie on a size 18, or smaller, barrel swivel. Now use a 10 to 15 foot mono or fluorocarbon leader to tie on the lure.
What line to use for trolling for walleyes?
monofilament line
For most walleye trolling applications 10 to 14 pound test monofilament line is the ideal choice. Lines of this pound test rating are more than strong enough to handle even big walleye, yet thin enough to enable crankbaits and other popular trolling lures to reach substantial depths.
How much line should you let out when trolling?
Let out 50 feet of line and clip into the release. If that’s not enough distance to prevent your lake’s wary walleyes from seeing the ball…then let out 150 feet of line! Just remember, the flat-line diving depth of your crankbait still applies behind the ball!
Should you troll with or against the current?
Just remember, if you go with the current, you will have to troll faster than the current to achieve the best action for your lure. 85% of the time I troll against the current. It gives you more control working the breaks, and better bait action.
How do you rig for walleye trolling?
Walleye rigs for trolling The lindy rig is the best choice for presenting your bait within a few inches of the bottom, while the bottom bouncer allows you to present it about a foot above the bottom. The 3 way rig allows you to present the bait even higher, up to 4 feet above the bottom.
How do you calculate troll depth?
Consider the following example: If you’re trolling a tandem rig tied with two five-ounce bucktails (5 x 2 = 10), and you let out 100 feet of line (double 50, so multiply by two again), according to the Rule it will run at about 20 feet below the surface (5 x 2 = 10 x 2 = 20).
How do you get deep without a downrigger?
You can add lead weights to the line or use a diving device. In both cases, the weight or diver is attached to the main line with the lure or bait tied to the terminal end using a leader that is lighter than the main line. As you let out more line, your gear will descend to the desired depth.
How to catch walleye with jigging spoons?
with a 12-20 pound line and 3-5 inch lures or spinners. lures or spoons cast as far out as you can comfortably reach. that your lure will ride up on the bottom after you cast. What is the Best Barometric Pressure for Walleye Fishing?
How do I lower my speed for trolling?
Troll Along With the Currents. Want to know the secret that will keep your lure at the depth you desire?
What is the best way to get trolling speed down?
“The best way to control speed is to watch your skirted baits and keep bumping up faster and faster, until your baits start to spin,” says Capt. Anthony Mendillo, of Keen M Sport Fishing in Isla Mujeres, Mexico. “Then slow down until your presentation swims true, and you’ve found your peak natural-bait trolling speed for the day.
How to use a Jigging Rap for walleye?
Using a small plier, pull the hook out about 5 degrees. The simple J doesn’t do a great job on hooksets out of the box. You’ll notice more treble hooks in and around the mouth this way. Swap out the hook for a longer shank treble hook. When you’re ripping the rap, you’ll see more hooksets from the treble this way as well.