Where is the injector pump located?
In petrol engines, the fuel pump is usually located inside the fuel tank. In diesel engines, the fuel tank holds an auxiliary pump, while the injection pump, generating high pressure and controlling the order in which the injectors are opened, is located next to the engine.
What is the fuel pressure on a 3406b?
cranking fuel pressure is 38-42psi minimum.
How much HP does a CAT 3406 A have?
Based on its specifications, you can expect between 250 and 550 horsepower from the 3406, at an rpm range of 1,600 to 2,100. According to Wikipedia, the power consumption of this engine ranges from 1,000 pounds to 1,850 pounds at 1,200 rpm.
How much power can a 3406B make?
How much torque does a 3406b have? Horsepower and Torque Depending on its specifications, the 3406 engine can produce anywhere between 250 horsepower at 1,600 rpm and 550 horsepower at 2,100 rpm. It can produce between 1,000 pound-feet of torque at 1,200 rpm and 1,850 pound-feet of torque at 1,200 rpm.
How much HP can you get out of a 3406B?
I found a Cat 3406B, DITA. It is currently rated at 360 HP. Are there different hard parts inside between lower and higher HP models?
How long does it take to change an injector pump?
Well-known member. A few people fully remove all the injection lines to get the pump out. That is not needed though. Follow the directions in the -20 and it will take 2-4 hours.
How much boost can a 3406b handle?
It is also rated 425 hp. When pulling hard at 1500 rpm or better, it has 22.5 pounds of boost. My fuel pressure gauge does not move depending on the load. It pretty much stays the same.
How much power can a 3406b make?
How much boost can a 3406B handle?
When did the 3406B come out?
What Year Did The Caterpillar 3406B Come Out? What year did the 3406b arrive he 3406b come out?? During 1973, the CAT 3406 satellite was released.
How to remove fuel injection lines from a Hyundai Armado 3406?
Desarmado y Armado 3406 ENGINE FOR GENERATOR SET Fuel Injection Lines SMCS – 1252-11 ; 1252-12 Remove Fuel Injection Lines Ver imagen Ver imagen 1. Remove nuts (1) and the bolts that hold fuel lines (2) in place on the engine. 2. Use tool (A) and remove fuel injection lines (2) from the fuel injection pump and cylinder head. 3.
How to install fuel injection pump?
Look inside the bore of the injection pump housing to find the dowel. Put groove of the barrel in alignment with the dowel and put the injection pump straight down into the bore. 4. Use tool (A) and install fuel injection pump (1) in the fuel injection pump housing.
How to change the rack position of the injection pump?
Put the groove of barrel (2) in alignment with the slot of the gear segment (the slot is on the opposite side of the gear segment teeth). 2. Move lever (3) forward to move the rack to the center position. 3. Look inside the bore of the injection pump housing to find the dowel.