How do I program a Compustar module?
STEP 1: Activate programming mode by manually turning the vehicle’s key between the Ign On and Off (or the Acc & On positions) five times within 10 seconds. The vehicle’s parking lights will flash once with the successful completion of this step. 2 remotes please program each remote twice.
How do I flash my Compustar remote start?
While keeping your foot on the brake, press the remote start button on your remote control for 2.5-3 seconds. Your parking lights will flash once. Turn off your vehicle’s engine and remove the key from the ignition. Retry remote starting your vehicle using your Compustar remote.
Are remote starters hard to install?
Remote starters are convenient, inexpensive and easy to install. Learn about remote start installation here. Install a remote starter for your car yourself. It’s a great upgrade, inexpensive and a project you can do yourself with simple tools and the supplied wiring diagram.
How do I program my remote starter key fob?
Follow these steps to program a key fob at home:
- Replace the batteries inside the key fobs.
- Get inside the car.
- Turn on the ignition.
- Press the lock button on the remote key.
- Listen for a Lock Sound.
- Programming additional remotes.
- Turn off the ignition.
- Step out from your car and test the result.
Where do I mount my CompuStar antenna?
The Compustar antenna will normally be installed behind the rear view mirror and attached to the windshield. If you have the ANT-2WFMX antenna installed, it will have a blue LED light built on the back of it that will flash to act as a security deterrent light.
Why do my lights flash when I remote start?
The blinking lights are a visual indicator and precaution to you and others that the vehicle engine is running. The parking lights will blink until the vehicle is turned off or until you enter the vehicle with the Smart Key fob.
How do I use the Compustar 700r remote start?
Tap the Unlock Button to unlock your doors and/or disarm your vehicle. Hold this button for 2.5 seconds to pop your trunk. If not equipped, ask your Authorized Dealer for details on how to get it. Hold this button for 2.5 seconds to start your vehicle.
How do I program my GM key fob with remote start?
On your Chevy key fob, press and hold the “Unlock” and “Lock” buttons simultaneously until you hear the door locks engage and disengage again, indicating that you have successfully programmed your key fob. Re-insert the newly programmed key into the ignition in the “On” position to end the programming sequence.
Can I get push-to-start installed?
Since vehicles with push-to-start technology are becoming more and more popular, you might wonder if it’s possible to add an aftermarket remote starter to your keyless ignition system if it didn’t come with one installed from the factory. The good news is, yes, you can do it.