What is the thing called that holds the curtain rod?
Brackets, also called supports, are the hardware pieces that hold the rod. Curtain rods are always attached to the wall or ceiling with brackets.
What can I use for curtain rod brackets?
You’ll need to use plastic wall anchors to provide proper support if you’re installing in drywall. Fasten the brackets to the walls using your drill or screwdriver. Having a hand tool ready often makes this job easier, since it can be hard to use a larger electric drill when mounting curtain rod hardware to the wall.
Where do you place brackets for curtain rods?
Each bracket should be placed at the height you previously determined and about four to six inches from the side of the window frame. (This will allow you to open the curtains completely.) Check to make sure your pencil marks are level otherwise the entire window treatment will be crooked.
Do you need 3 brackets for curtain rod?
Over 96 inches, a third rod bracket is required as a center support; this is mandatory! Having said that, a 2 inch or 3-inch diameter pole can span a distance up to a full 12-feet without flexing or bowing using only two end brackets.
Do curtain rods come with brackets?
They typically have some sort of a stopper or cap on each end and come with brackets to hang the pole on. Curtains hang on them with either fabric tabs or clip-on curtain rings. The most standard curtain rod sizes are 28- to 48-inches, 48- to 84-inches, and 66- to 120-inches.
What is a return bracket?
Short or Standard Return Brackets are brackets with a return ranging 3 inches to 4 inches. For basic drapery hardware, such as traversing rods, or decorative telescoping rods, standard return brackets are usually adjustable with a 3 1/2 inch to 4 1/2 inch return range.
How many brackets do I need for curtain rod?
Count how many brackets are included with the curtain rod. As a general rule, there should be at least one bracket for each outside corner of the window, and one bracket in the center. Add more brackets if the expanse between the middle and outer brackets is more than three feet.
How wide should curtain rod brackets be?
Curtain rod brackets are available in two standard sizes: 5/8-inch and 1-inch widths.
Do I need a middle support for curtain rod?
If your curtains cover a lengthy window span, you’ll need a functional support bracket in the center to prevent the rod from bowing. Most rods require support brackets every 30 to 36 inches. So if your window is longer than 60 inches across, you’ll need two center support brackets.
Do you need middle bracket on curtain rod?
A center bracket is needed in almost any length greater than 5 to 6 feet, if you want to avoid any sagging. However there are “C” rings that will go over the bracket so that the drapes/curtains can be pulled to one side (either side, in fact).
How do you measure curtain rod brackets?
To determine the optimal width of your curtain rod, you’ll need to measure the width of your window including the frame or trim. Take this measurement three times: once at the top, once at the center, and once near the bottom of your window.